| Command |
Description |
| |
defines a comparison between the signals in a specified reference design and the signals in a specified test design |
| |
allows a difference to be flagged as ignore, or an additional text string to be attached |
| |
defines a clock for clocked comparison; or, if -delete is specified, deletes a previously-defined clock |
| |
deletes a signal or region from the current open comparison. |
| |
destroys the compare data structures and forgets clock definitions and signals selected for comparison |
| |
writes out results of the comparison; writes to the transcript unless the
-write option is specified |
| |
shows all the compare region and compare signal commands currently in effect |
| |
sets values for various compare options on the Tcl parser side; when subsequent commands are called, these values become the defaults |
| |
clears the current compare differences, allowing another compare start to be executed |
| |
reloads comparison differences to allow viewing without recomputation |
| |
registers required callbacks and runs the difference computation on the signals selected for comparison; reports the total number of errors found |
| |
saves the comparison result differences in a form that can be reloaded later |
| |
saves the comparison setup information (or "rules") to a file that can be re-executed later as a command file; saves compare options and all clock definitions and region and signal selections |
| |
causes the specified compare difference to be made visible in the specified wave window, using whatever horizontal and vertical scrolling is necessary |
| |
initializes internal data structures for waveform compare |
| |
used internally by the compare stop button to suspend comparison computations in progress |
| |
used internally to update the comparison differences when comparing a live simulation against a .wlf file |
