Overviews

Commands

See Also

To specify Simulator time and vector settings:

You can also specify all Simulator settings with the Simulator Settings wizard.

1. If you have not already done so, create a new project or open an existing project.

2. Choose Settings (Assignments menu).  Shortcut

3. In the Category list, select Time/Vectors under Simulator Settings.

4. If you wish to run the simulation to the end of the stimulus file, under Simulation period, select Run simulation until all vector stimuli are used.

   or

   To specify a specific end time, under Simulation period, select End simulation at, and type a time in the box.

5. Under Vectors, specify the source of any vector stimuli in the Source of vector stimuli box.

6. If you wish to automatically add all output pins in the project to the simulation outputs, turn on Automatically add pins to simulation output waveforms.

7. If you wish to automatically display a comparison of expected outputs versus actual outputs in the Simulation Report, turn on Check outputs.

8. Click OK.

Back to Top