Overviews

Commands

See Also

To draw a conduit, bus, or node:

1. If you have not already done so, open or create a Block Design File (.bdf).

2. To draw a conduit, click the Orthogonal Conduit Tool button   or the Selection and Smart Drawing Tool button   on the toolbar.  More Details

3. To draw a bus, click the Orthogonal Bus Tool button or the Selection and Smart Drawing Tool button   on the toolbar.

4. To draw a node, click the Orthogonal Node Tool button or the Selection and Smart Drawing Tool button on the toolbar.  

5. In the Block Editor window, click any empty space to define the start of the connector and drag the pointer until the connector is the correct length.

Back to Top