Overviews

Commands

See Also

To set up a SignalTap^® II File (.stp):

1. If you have not already done so, perform an analysis and synthesis, an analysis and elaboration, or a compilation on the design.

2. If necessary, open a STP File, or create a new STP File.

3. In the SignalTap II Logic Analyzer window, click the Setup tab.

4. If you want, add instance(s) to the STP File.

5. Assign nodes to each instance.

6. If you want, assign one signal as the SignalTap II Logic Analyzer clock.

7. Set the sample depth for the STP File.

8. If necessary, specify nodes for data and/or trigger acquisition.

9. If you want, specify nodes for SignalTap II incremental routing.

10. If you want, set the trigger input.

11. If you want, set the trigger output.

12. If you want, assign a signal to the debug port.

Back to Top